
144
8048C–AVR–02/12
ATtiny43U
19.3.1
Signature Bytes
All Atmel microcontrollers have a three-byte signature code which identifies the device. This
code can be read in both serial and High-voltage Programming mode, also when the device is
locked.
The three signature bytes reside in a separate address space called the device signature imprint
table. The signature data for ATtiny43U is given in
Table 19-7.19.3.2
Calibration Byte
The device signature imprint table of ATtiny43U contains one byte of calibration data for the
written into the OSCCAL register to ensure correct frequency of the calibrated oscillator.
19.4
Page Size
19.5
Parallel Programming Parameters, Pin Mapping, and Commands
This section describes how to parallel program and verify Flash Program memory, EEPROM
Data memory, Memory Lock bits, and Fuse bits in the ATtiny43U. Pulses are assumed to be at
least 250 ns unless otherwise noted.
19.5.1
Signal Names
In this section, some pins of the ATtiny43U are referenced by signal names describing their
in the following table are referenced by pin names.
Table 19-7.
Device Signature Byte
Part
Signature Byte 0
Signature Byte 1
Signature Byte 0
ATtiny43U
0x1E
0x92
0x0C
Table 19-8.
No. of Words in a Page and No. of Pages in the Flash
Device
Flash Size
Page Size
PCWORD
No. of Pages
PCPAGE
PCMSB
ATtiny43U
2K words
(4K bytes)
32 words
PC[4:0]
64
PC[10:5]
10
Table 19-9.
No. of Words in a Page and No. of Pages in the EEPROM
Device
EEPROM Size
Page Size
PCWORD
No. of Pages
PCPAGE
EEAMSB
ATtiny43U
64 bytes
4 bytes
EEA[1:0]
16
EEA[5:2]
5